Restricting Good Receipt Unless Production Order Confirmed

[Former Member]

Hi

Experts,

I want to Restricting Good Receipt Unless Production Order Confirmed

I am doing following thing but the error is occured.

Use Tcode BS02 ( Customising USer status profile).

2. Select the order type which you want to configure (eg:PP000001) and choose "Details" button.

3. In the User status table do the following:

a. In the status no field type"1" , status field "Sta1", short text"GR not allowed", lowest no "1", Highest No "2". Mark a tick in the initial stats check box.

b.Next line, type status no field "2" ,status field "sta2", short text"Gr allowed", lowest no "2" , highest no "2".

4. Select the STA1 line and choose details. select the "create"button.select the "GR for prod order", mark "forbidden

radio button" and "set radio button".

5. Select the STA2 line and choose details. Selct the "create"button. select "confirm order", mark "permitted radio button" and "set radio button". Next choose "GR for prod order" , mark "permitted radio button".

6.Save.

Create a prod order and check whether the required scenario is working.

I have created user status profile as PP000001 GR

ERROR

First define allowed object types

Message no. BS218

Diagnosis

The object types for which a status profile may be used define which business transactions are included in business transaction control.

Procedure

First define for which object types this status profile can be used.

What is object type how to define?

Thanks & Regards

Pert

[Former Member · Accepted solution]

Hi,

Refer to the below thread which addresses the same need:

Revert if you face any issues.

Regards,

Vivek

[Former Member]

To Dear ,

Here you can use user exit where you can keep check on confirmation .If confirmation not done system should throw error when you will do Goods Receipt .

Regards

SANIL

[Former Member]

Have you assigned the status profile to the order type?

At what point you are getting the error?

Edited by: snigdho on Feb 1, 2010 8:30 AM

[Former Member]

Hi.

Sorry wrong thread reply

Regards,

Vishal