Skip to Content
Former Member
Jan 18, 2010 at 06:00 AM

KEA0 - Activate operating concern


Hi ,

I was trying to activate the Operating concern 1000 in QA but I am getting the following Error which can be seen in the action log in T code KEA0.

Error: Error generating table KOMPAKE

Message no. KE434

I found only one OSS note 207542 and a best practise document , on searching, but the note seems to be not valid for us

Extract from a best practise document

Error executing transaction KEA0 or KES1

Only in the case if you get an error executing installation step KEA0 or KES1 (168, e.g. installation step Maintain Characteristic Values):

Execute the report RKEAGENV as described in note 64490. Maybe you get an error during the execution, but the inconsistencies are resolved. Now, reactivate the operating concern (transaction KEA0, Tab Environment, cross-client and client-specific part). Just in case the error still exists, check note 942785.

This did not work for us

I executed the transaction /nSMB/BBI and got the message as transaction does not exist and so i have asked the Basis consultant to look at BB 168 (Profitability Analysis): Error generating table KOMPAKE, Message no. KE434

If the eCATT /SMB15/KEA0_O042_J17 "Activate Operating Concern" shows the error Error generating table KOMPAKE, Message no. KE434. Diagnosis: An error occurred while Table KOMPAKE was being generated. restart the Solution Builder project again. The error should then not occur anymore.

Please throw some light on this , whether am i missing some thing or going in the right direction to sort this issue out.

Thanks in advance


SAP student

Could you please help on this.