Skip to Content

How to pass Dynamic Selection of Ecc tcodes in ECC Drill through

Dear Experts,

My client wants to drill through to Ecc tcodes based on dynamic selections (as attached in screenshot: screenshot 1)

I passed the technical name of that dynamic selection in Drill through selection (screenshot 2 & 3)

I am getting the error (as attached in screenshot 4)

If i pass the parameter of selection screen, the drill through properly works.

Version: SAPK-81008INCPMBPC

screenshot3.pngscreenshot4.pngscreenshot1.pngscreenshot2.png

screenshot1.png (13.1 kB)
screenshot2.png (22.7 kB)
screenshot3.png (32.3 kB)
screenshot4.png (8.5 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Nov 24, 2016 at 12:53 PM

    Sorry, but not clear and not readable!

    What do you mean by "If i pass the parameter of selection screen, the drill through properly works."

    Can you show something working?

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 24, 2016 at 03:34 PM

    Sorry Vadim, I can't access ecc from other network. (If required, i will share the screenshot tomorrow morning once i reach office)

    From this sentence, "If i pass the parameter of selection screen, the drill through properly works.", what i want to convey is (see screenshot 1), if use the highlighted s1.png parameter, use that parameter in drill through configuration s2.png s3.png, the drill through works properly as mentioned in the your mentioned link.

    The only requirement I have is that I want to run the report through dynamic selection screen s4.png, and if i pass that parameter, then the drill through is not working properly.

    Hope this would have clarify your concern

    Regards,

    Rahul

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 24, 2016 at 04:07 PM

    OK, now it's clear! No idea how to work with fields in dynamic selection. Never tested myself.

    Add comment
    10|10000 characters needed characters exceeded