on 01-04-2010 12:14 PM
Hi friends
Any t.code for deleting MIC or Characteristics or Parameter in QE01 or Result Recording(QA32)
Thanks & Regards
Gajendranath
Hi
100% u can do,first you delete the MIC in your inspection plan (Qp02), Then you reset the sample thru by QAC3 t-code, then u will do again assign and sample calculated thru by QA02 ,now open your result recording screen , that inspection lot changed as per your new inspection plan, i hope you this is use full for you, if u do not change mean plz reply me..
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi sujit
Solved, thank u very much
Thanks & Regards
Gajendranath
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
while dong the RR you can not delete the char/MIC as while creation of inspection lot only task list gets attached.
So what you can do the remove the task list from the lot,
In QA02>enter Inspec Lot->click on Reset sample.--->save.
This will remove the task list & status of lot will become CRTD from REL.
Now you can change the task list & attach the task list through QA02>click on Inspec specs->save.
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.