Skip to Content

ATC System ID not populated

Hi all.

We are trying to finalise our setup of Central ATC. First thing i've observed is that not all checks are working, some are critical from our POV and they are not available for remote access.

Rest seems to be working except for calculation of System ID. In 0SM_ATC cube i see entries coming from different runs. However, all of them belong to the same System ID which is not correct.

Our QA system performs checks every week in all our development systems. Results are saved in QA system and then transferred to Solman cubes. Problem is that System ID is always populated with same ID which is not correct. This has big impact in our queries as most of them have System ID as selection parameter.

Any idea of what we might have missed during setup? I guess issues should be in CCLM config but i'm not completely sure.

Thanks for you help!

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • Jul 11 at 09:52 AM

    Hi,

    If I understand correctly, you have scheduled some ATC runs on your QA system, and you used the CCLM ATC results extractor to extract these runs to BW, right ?

    If so, all of these runs should have system_ID = your QA system.

    What system ID do you see in the results ?

    Or, are you using another system as ATC Hub for remote ATC analysis ?

    Add comment
    10|10000 characters needed characters exceeded