on 12-11-2009 10:45 AM
Hi,
Need help on the following issue.
In quality inspection scenario, raw materials eg: Chemicals are purchased and they are put in to quality inspection. And these chemicals will undergo quality checks for different characters such as pH value.
How do i maintain the result of quality checks such as pH - 5, in the system?
Thanks and Regards,
Pavan
thanks for the help...
Pavan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Pavan
1) Create a MIC using QS21 as pH and you can give the values as -5 in that.
2) Attach this mic in the inspection plan using QP01
3) In result recording you will get the spec values and you can record your values
Just the basics
please let me know your feedback
regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
1.Ceate Material Master & Maintainn QM view for the same.In Qm view mainatian Inspection with task list & "Check char" along with the "auto assignment"
2.In QP01 create a Task list/Inspec plan for same material with Usage:5 & status 4
3.In Inspection plan now maintain Ph values for different characteristsics.
Select say Ph1( for X ) ,Quantitave Inspection along with fixed scope etc etc.
Ph2( for Y ) ,Quantitave Inspection
4.Create sampling procedure for the sample size (you may use fixed sampling ) in QDV1
5.Assign this against the Inspection char in QP01/2
Now create a Inspection lot.Check the status of the lot is REL.
In QS32 You can do Result recoring ,defect recording & Usage Deciosn.
or use QE01/QE70
I hope this help
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi sujit,
i have maintained all settings as u said.
material is chem-1, QM view - inspection type - 05, i have maintained indicators insp.with task list, auto. assignment, Check chars.
i have created MIC- PH, quantitative char. ticked, I also maintained lower, upper limits and target value.
i have defined sampling procedure, and maintained, MIC and Sampling procedures in inspection plan.
i am using t code QA32, to maintain results of the quality inspection. but here i cannot find any MIC field where in i can maintian values...!! i want to input the inspected values, how can i do it?
please let me know where i am going wrong.
Thanks
Pavan
User | Count |
---|---|
100 | |
11 | |
11 | |
6 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.