Setllment Order not determine 2nd time

[Former Member]

Hi,

I am maintaining settlement order in maintenace order's Location tab.

My settlemnt rule automatically picks this order as a settlement resiver.

But if I chnaged that settlement order in location tab then system not changes the settlemnt reciver with new order which i have mantain in settlement order field.

I want that system should chnaged the settlement resiver if i changed the settlment order in case cost is not settled on that order.

Regards

Rakesh

[Former Member · Accepted solution]

Ganpat,

I think this is not available in std. You need an exit for this to trigger at save event checking the settlement receiver similar to the order maintain in your location tab.

Try this IWO10027 I havnt tested.

DP

[peter_atkin]

Rakesh,

Once the settlement rule has been determined once, the system will not redetermine this value. This is a standar problem...

You can use user-exit IWO10009 (at save event) to make comparison checks and issue an error message if required.

See the user-exit link at the top of this forum.

PeteA