Hello Experts
In Production server when our PS person try to attach Genral Legders of WIP in settlement Rule Maintance of WBS Element in Project Builder(CJ20N),system gives following Error :-
Total = 200.00%, ( Set.Type FUL / Version / Actual settlement ), period 008/2009, source assignment COE
Message no. KD041
Diagnosis
You entered distribution rules which settle 200.00% in total. This applies to view/version/settlement type ( Set.Type FUL / Version / Actual settlement ) and source assignment COE in period 008/2009.
When checking the percentage total, the system found one of the following errors:
u2022 The total percentage for the distribution rules is greater than 100%
u2022 The total percentage for the distribution rules is less than 100% and this is a rule for full settlement (settlement type FUL).
u2022 The total percentage for the distribution rules is less than 100% and the 100% check is switched on in the settlement profile.
If you are using a source structure and source assignment " ", note the following:
Source assignment " " is assigned to all possible origin assignments in the structure you are using. This is even if you did not specifically use the corresponding source assignment.
Example:
Source assignments (SA) A and B are defined in your structure. You specified two rules:
u2022 SA ' ' 70%
u2022 SA 'A' 30%
The system outputs an error message for OA "B" because this only displays 70% (from SA " ").
Procedure
If you are settling using fixed amounts you can ignore this message. The settlement then checks whether the settlement sender is fully credited.
Otherwise, correct the percentages for settlement type ( Set.Type FUL / Version / Actual settlement ) and source assignment COE, so that you are settling exactly 100% in period 008/2009.
If you do not have full settlement rules, you can switch off the 100% check in the settlement profile. This procedure also suppresses the message in future.
Note
If you cannot find any fields where you can enter percentage values, this is probably because the settlement profile is configured to hide them. Switch on percentage settlement in the settlement profile. Alternatively you can use equivalence numbers for your rules, if the project profile allows this.
We are facing this problem for the first time whereas same type of attachment we had done for our privious project.
This is our new project & we are trying to attach to lower level of WBS
Kindly Help for the same