Hi All,
Please note we are already using EXIT_SAPLV01Z_001, EXIT_SAPLV01Z_002, EXIT_SAPLV01Z_003, EXIT_SAPLCLFM_002, EXIT_SAPLV01Z_012, EXIT_SAPLV01Z_014 for Batch creation based on different logics for Material type, Plant and PO doc type and currently using these exits for logic it allows us to ℹ️ create new internal batch number during PO creation (ii) change already existing batch with some new number (of couse this number must not be used in some other PO) in PO change and (iii) create new internal batch number using MSC1N, by inputing plant, stor. loc etc. But currently i can create batch with 1 digit, 2 digit, and so on.
The requirement is to allow user to create batches only with 10 digits during:
(i)PO creation (ME21N)and PO change(ME22N) and also during
(ii) transaction MSC1N
currently in all three ME21N, ME22N or MSC1N it allows to create batch with 1 digit, 2 digit,3 digit and so on . i want to create batch with only 10 digit.
Please tell this is possible through configuration steps or some changes are required to be done in above said user exit.
Regards
Rahul Shukla