on 11-26-2009 4:51 AM
In a plant if there are some 100 x materials and 100 y materials..
The requirement is when the 100x materials are planned ,The 100 y materials should not be planned(i e 100 y materials should not be considered in planning). How to map this in MRP.
I have heard that using MRP controllers or MRP areas this can be achieved.But I don know how?
If anybody cud help me in how to proceed this?
Dear Anujah,
Assuming you have created 2 different MRP controller say M01,M02 and M01 is assigned in the material master of X and M02 is
assigned in the material master of Y,then while executing MRP at plant level you can activate user exit M61X0001 in order to
restrict the MRP run based on MRP controller.
Regards
Mangalraj.S
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Anujah,
You can achive this through MRP area. Do the following customization settings
1. Activate MRP for MRP area.
2. Defien MRP Area for sto loc. Say your X matrerial are at sto loc X0001
3. Define scope of planning for total panning run. Here enter your MRP area.
Now Go to MD01.
In scope of planning enter plng scope define for materail X & run MRP. It will only run MRP for material having sto loc X0001.
Regards
Abhijit Gautam
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI
This can be achieved through the user exit in MD01 based on MRP controller assing different MRP controller for X and Y material and with the help of ABAP you can use exit in MD01 and run mrp with that exit in MD01
sorry the user exit which is used in my scenario which is same as of yours is M61X0001 as Suggeste by Mr Mangalraj
Regards
Anupam Sharma
Edited by: anupam sharma on Nov 26, 2009 11:15 AM
Edited by: anupam sharma on Nov 26, 2009 11:17 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.