Last delta incorrect. A repeat must be requested.This is not possible

[Former Member]

Hi,

Standard extractor 0FC_ACCNTBP_ATTR runs diary through a process chain where there is a change run process for 0FC_ACCNTBP characteristic. Three days ago this process chain canceled on its change run process so that the subsequents delta extraction canceled too because the characteristic was locked by the terminated change run process.

I removed these locks and I could successfully repeat the terminated change run process. But when I try to repeat a delta load for 0FC_ACCNTBP characteristic I receive the message "Last delta incorrect. A repeat must be requested.This is not possible".

It is known that there are some standard characteristic that don't support delta data load repeatition. In that cases I used to turn terminated process monitor general status to green and run a new delta load process. But this case is different because there is no log monitor for terminated delta extraction. As the characteristic was locked, load process didn't even start.

Does anybody know how to solve it? Is there any function module to run in order to reset the status and continue normal data load in the characteristic?

Thanks in advance.

Best regards.

Ana Gabriela

[former_member181964 · Accepted solution]

Hi,

Generally if Delta load is failed then you need to check the Request in CUbe/ODS and then make it red and delete from Cube/ODS and then run the same Delta InfoPackage manually, it will ask Lat delta is failed and no new delta possible and do you want to repeat delta, the you SAY ok and Run it, it will success.

You check the entries in RSA7, select your datasource and click on Display and select Repeate delta and see the actual data.

Thanks

Reddy

[Former Member · Accepted solution]

Hi Surendra,

When I try to run delta infopackage mannually (the SAME as tha cancelation one) I get the following message:

"Last delta update is not yet completed. Therefore, no new delta update is possible. You can start the request again if the last delta request is red or green in the monitor (QM activity)."

But there is no monitor for this loading because it never started because of the locks I told you.

After this message, system informs "Action was cancelled. Message no. RSM513".

Is there any thing I can do to start the cancelled process in order to have any monitor log?

Thanks.

Ana

[Former Member · Accepted solution]

In RSA7 transaction when I select "Delta repetition" I obtain message "List contains no data".

[Former Member · Accepted solution]

I could identify the wrong petition. It was in green status in characteristic "Manage" option however load monitor was failed. I turned it into green status and run a delta extraction. This one ended successfully.

Thanks for your help.

Regards.

Ana G.

[Former Member]

Hi,

Are you not getting the process monitor on the right click of the failed load in the process chain?

--

rgds,

[Former Member]

No, there is no monitor of loading process by right clicking on the terminated process.