on 11-25-2009 4:31 AM
hi,
Can anyone help me on fuel consumption? how shall i configure it and what are the transactions needed.
thank you
the Average Consumption is computed as Liters/100km.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
For using IFCU Transcation you need to customize following in SPRO
Units of Measurement for Monitoring of Consumption
Create Measurement Positions for Fleet Objects
Define Calculation Method
Define Gas Station
Define Key and Cost Object for Updating Material Documents
Hope this will help
Regards
Pravin
Edited by: Pravin on Jan 29, 2010 12:46 PM
Hi gurus,
When i go to tcode IFCU and click on fleet information button everything shows up except for the "Average Consumption" it shows 0.00 km/li
are there any additional configurations that i should do for this to compute?
Thanks for the help.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
can anyone help me on how to use Tcode MCIZ - Vehicle consumption analysis?
it says no data exists for the chosen selection. where can i put the fuel consumption and mileage?
thanks a lot.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Check transaction [IFCU|http://help.sap.com/saphelp_erp60/helpdata/EN/54/362fd16cba11d6b23400508b5d5211/frameset.htm]
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
1. For calculation of average consumption values you need to config -- define calculation method for fleet consumption values and use that consumption key in fleet master record in Calculmethod field in Vehicle technology tab.
2. For calculation purpose you need to have min 02 measurement documents in short term and longterm analysis period ..
3. For proper usage of IFCU Tcode do the configs under consumption relevant counter update ..
4. For usage of MCIZ do the config under PM -->Information systems -->configure measurement document update.Here plz read the documentation clearly and do the config ..
regards
pushpa
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.