on 11-20-2009 5:45 AM
Hi all ,
after inspection lot creats , in sample tab we need that by default number shuld come at " No of container" key ,say fix conatiner 2. pls suggest which setting is to be needed . And little explaination about Sample tab...
Regards
prerna
Hi
check user Exit :QEVA0005 User subscreen for displaying add. data for usage decision
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Icon of sample calculation means the sample size of the inspection lot is to be determined.
It has Relation with the sampling procedure which you will either use in the task list (against characteristics) or in Inspection type.
Depending upon the valuation type & valuation mode sample size will be calculated,
If you do not use sampling procedure & you are using task list then sample size will be 100% of lot size.
If you do not use sampling procedure & you are not using task list then sample size will be 0.
I hope you understood.
Regards
Sujit
Dear Prerana
The Container field in the inspection lot gets updated automaticaly if you have keyed the same while doing the GR
But make sure that you have the plant level setting done for the same
SPRO > QM >Basic Setting > Maintain Settings at Plant Level > inspection lot creation tab > Enter container at GR > Recording of Number of containers possible or + recording of number of containers required
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Prerana
Please let me know whether your GR is based on container basis. Is the container been entered while doing the GR
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
7 | |
7 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.