Skip to Content
avatar image
Former Member

table to get the storage location in WM for the corresponding TO

Hi experts. I have a tough problem about how to get the right table to show the source (or target) storage location for the transfer order if the source(or target) storage location is not under warehouse management.

Here is the scenario, now I need to develop a label about transfer order, the requirement is that once the source(or target) storage location is not under warehouse management, I need to output that storage location.

Can anybody give me the right logic to get that value? Thanks.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Nov 17, 2009 at 11:31 AM

    Hi

    Pass the plant into the Table T001L and get all the SLoc's. Pass the Plant and all those Sloc's into the Table T320 and you will get the Sloc's which are WM managed. Rest all the other Sloc's are not mapped to any W/H.

    Pls check once.

    Regards

    Amuthan M

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 18, 2009 at 12:05 AM

    Can you clarify your problem? Are you saying that you are transferring material from a non-wm managed storage location to a wm-managed storage location? If so, the TO would have the material document number in LTAK-MBLNR. You could use to find source storage location and do a look-up on T320 to see if your warehouse is assigned.

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 18, 2009 at 07:27 AM

    Hello,

    Use T code SE16N-> enter table T320-> Execute. You will get all the plant --Sloc combinations that are are WH managed

    Thanks ,

    Milind

    Add comment
    10|10000 characters needed characters exceeded