Skip to Content
avatar image
Former Member

Configure Network Printer in SAP

Hie Guru

I have been able to configure a network printer that is connected to a PC using Access method S and installing SAPSPRINT on the printserver. I'm now faced with a challenge on configuring a stand alone network printer. I would like to kno w that since this Ptinter is not connected to any PC were do i install SAPSPRINT. I'm also not very sure if the entries i made in Tcode SPAD are correct.

Access Method: U

Host printer: <name of printer>

Destination Host: <IP Address of the Network Printer>

Please any suggestions are welcome!

Regards

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Nov 16, 2009 at 05:14 PM

    Hi

    It's realy tough to list all steps require to configure printer. So please go through below links and follow the instructions.

    Please note, it's only informative references thus you require to take the right dicesion.

    http://help.sap.com/saphelp_nw70/helpdata/en/d9/4a956151ea11d189570000e829fbbd/frameset.htm

    http://www.oit.state.pa.us/ob_imaginepa/lib/ob_imaginepa/sap_support/sapprintguide.doc#Ai

    Regards

    Sekhar

    Add comment
    10|10000 characters needed characters exceeded