Error while posting Inbound Idocs-"EDI: Partner profile not available"

[Former Member]

Hi,

I am getting the error "EDI: Partner profile not available" Status -56 while creating inboud Idocs.

I have done the following steps so far

1.Created IDOC basic Type and Message Type. (Custom)

2. Created process code to process the IDOC.

3. Use the FM IDOC_INBOUND_WRITE_TO_DB to create the inbound IDOC.

4. Use the FM IDOC_START_INBOUND to process the IDOC.

Is ther anything else that i have to do inorder to post the idoc sucessfully.

Thanks in advance

-Nishant

Edited by: nishant patel on Nov 13, 2009 10:35 AM

Edited by: nishant patel on Nov 13, 2009 10:41 AM

[ravi_teja10]

1) Maintain partner profile: WE20 for your message type and idoc type

2) Fill Idoc control record 'EDIDC'

[Former Member]

HI Ravi,

I have already done that ..

Regards,

Nishant

[former_member181962]

Hi,

YOu have to create Partner Profiles for the partner who is sending this idocs in WE20 transaction.

http://help.sap.com/saphelp_nw04/helpdata/EN/dc/6b809b43d711d1893e0000e8323c4f/frameset.htm

Regards,

Ravi Kanth Talagana

[Former Member]

i have already created partner profile as

'ZDUMMY' and specifed an inbound parameter,

For the inbound parameter i have specifed the meassage type and also assgined a process code

[SuhaSaha]

Hello,

Did you define the Partner Profile as a Logical System?

If yes, then did you maintain the Logical System in BD54?

BR,

Suhas

[Former Member]

Yes i have done that too.

Thanks,

Nishant

[Former Member]

Hi,

Check in WE20 if the partner profile is configured for the idoc type and the message type. That might be the cause of the error.

Also make sure the same partner profile details are sent to the control record. Partner profile details are stored in the table EDP13.

Hope this helps

Regards

Shiva