Skip to Content
avatar image
Former Member

BOM BOS transfer

Hi,

I am getting an error message " Error in Parent Object" while i run BOM BOS transfer. There is no longtext for me to view the exact problem.

Can u let me know whatz the issue

Regards

Srikanth

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Nov 12, 2009 at 06:40 PM

    Hi,

    I don't have much information on this but i also had the same error when i was processing BOMBOS transfer, but when i executed after sometime there was no issues again.

    Try executing cg37 again , hope it also succeeds in your case

    Regards

    Ravindra

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 19, 2010 at 12:14 PM

    Check that you might have open the specification to where BOM has to be transferred....come out of that and execute again.....It will work.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hello,

      Thesre are following probable reasons for this:

      Check the filter criteria for the parant material.

      Also check the filter criteria for BOM items as well.

      The Specification or BOM is in edit mode- change this to display.

      If any one of this criteria is not fullfulling then also you will face this issue.

      Regards

      Sachin