cancel
Showing results for 
Search instead for 
Did you mean: 

SLT - Batch job for access plan calculation in sender system ended with errors

former_member390867
Discoverer
0 Kudos

Hi,

We are configuring SLT between ECC (Source) and S4-1610 (Target). When we tried to replicate table MARA for Initial load, it ended up with error "Batch job for access plan calculation in sender system ended with errors".

There is a batch job which failed in the Source ECC system, but we're not able to see any Job log. Note that there is no filter/code in the configuration of the Table MARA.

We saw this error for other tables such as VBAP, VBEP though the replication for table VBAK was successful.

We have below DMIS version in ECC.

DMIS 2011_1_731 0014 SAPK-11614INDMIS DMIS 2011_1

Can you please advise any hints to resolve this error.

Accepted Solutions (1)

Accepted Solutions (1)

andrey_martynov
Active Participant
0 Kudos

First of all, I hope you have already installed all notes, for corresponding release in source system. SP14 in most cases used remote generator for generation of runtime objects. It means that the code will be generated directly in source system. So all patches must be installed there.

Then in normal case the error from ACS should come into the central system and written into application log.

If you don't see anything, try follow: do you have an access into source ECC system? If you have you can first check the syntax error of the corresponding ACS function module and if it's ok, then try to run the function module. I guess you will get the some error very quickly.

If you have no error, then I recommend to open support ticket.

Answers (1)

Answers (1)

former_member390867
Discoverer
0 Kudos

Hi Andrey,

Thanks for your suggestion. There was some issue in the file system and BTC workprocess were less.

This was corrected and restarted, now initial load and replication are working.

Regards,

Harsha