Skip to Content
avatar image
Former Member

changing filename in configuration

hi there,

my question is can we change filename of a file in the configuration without using IR(that means no mapping was done)? the scenario is a simple file to file , the only problem is that the filename must be changed.

is it possible to do this without using a udf(dynamic configuration)?

thanks.

ali

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Nov 04, 2009 at 05:18 AM

    yes it can be done , in sender communication channel give the file name which ur getting and use " set adapter specific identifiers and file name ticked in " and in receiver communication channel give the desired file name and in advanced tick the adapter specific message adapters

    with regards

    Srinivas

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Not possible....there is no place where we can write a logic to read the incoming filename and then decide how to change output filename.

      Regards,

      Abhishek.

  • avatar image
    Former Member
    Nov 04, 2009 at 04:39 AM

    Not possible.....though in ID you check the ASMA checkbox and then the FileName, the input comes from IR (mapping).

    Regards,

    Abhishek.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 04, 2009 at 07:21 AM

    thanks folks

    Add comment
    10|10000 characters needed characters exceeded