Skip to Content
avatar image
Former Member

Master inspection characteristic: lower and upper limit control indicator

Experts,

When I create a MIC with reference to a class characteristic, I can not maintain the control indicator flags "lower spefic. limit" and "upper specific. limit". I can also not find these in any table (only in a structure).

But to use the note 119708 this is required.

Is there any way I can maintain this in the class characteristic? or how else can I overcome this problem?

Thanks!

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    Nov 03, 2009 at 12:23 PM

    Dear Jan

    if you are maintaining MIC with class characteristic in MIC lower and upper will automaticaly get seleted

    Regards

    Gajesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      When defining Class Characteristics please maintain range for the values Tab ex. 1-10 then automatically when you define MIC with reference to this Class Characteirtic Lower and Upper Limits are marked and would be same as that maintained in Class Characteristic which cannot be edited in MIC.

      Best Regards,

      K. Raghavendra Nayak

  • Nov 03, 2009 at 12:29 PM

    Dear Jan

    Hope you have chosed Data Type as NUM

    In that tick the intervals val allowed and in values you can maintain interval as 30 - 40 ( if the lower was 30 and upper was 40 )

    Regards

    Gajesh

    Add comment
    10|10000 characters needed characters exceeded