release strategy: PO not going for release after editing released PO

[Former Member]

dear gurus,

I have configured a release strategy using release indicator 4 and 6. the strategy is

1) PO value= 00- 10 000 purchase manager

2) = 10001 - 50000 GM Commercial

3) >= 50001 MD

suppose I create a PO of worth value below 9000 and saves it, release strategy is applied to it. then in ME29N we release it and save it. till here it works fine. but if I edit the released PO and the PO value changes to 15000 it should go for release again, this is not happening at my end.

can u pls suggest me if i m missing any config in between.

ujwal

[raghavendra_praveen · Accepted solution]

Hi

Check the release indicator % change in configuration and also check any version has been created because of change in value (PO -> header -> version ) accept the version then release strategy will be triggered.

Thanks

[Former Member · Accepted solution]

thanks

can u pls tell me how to accept the version after going to verion tab in PO

ujwal

[raghavendra_praveen · Accepted solution]

Hi

If you see any new version created (with numbers 1, 2 etc) flag the version as ok (tick the check box) and now save the purchase order, release strategy will be reset after accepting the version.

Thanks

[Former Member · Accepted solution]

hi sandeep,

thanks a lot, problem solved

ujwal

[Former Member]

Dear,

You have to make some slighter settings change in your release procedure:

Spro-MM-Purchasing-Purchase Order-Release Procedure for Purchase Orders-Define Release Procedure for Purchase Orders-Release indicator..

here you set changeble as "6" in fromt of your Release ID...

Try this it will work!!

regards

utsav

[Former Member]

Hi

Check in the Path

Spro-materials management-Purchasing-Purchase order- release procedure for PO-Def release procedure for Purchase order-Release Indicator

Here check what is the % change value you have given against your release Indicator.The % defined here will enable the system to reset the Release strategy once the value of the PO is Increased by this percentage

Also put the changeability indicator to 6

Regards

Sandeep

Edited by: sandeep13 on Nov 3, 2009 7:17 AM

[Former Member]

thanks,

i have done so but still the prob persists.

ujwal

[Former Member]

Dear Ujwal,

Have you tried my above suugested solution .

regards

Utsav

[Former Member]

hi,

yes , but the problem is still unsolved

ujwal