AFS : Add new size grid to the production order

[Former Member]

Hi,

My companies requirement is, add new size grid for the partially confirmed production order. This production order is created without BOM and components are attached at the point of creation and based on the routings the component allocation also done.

Can anyone help me to solve the issue. Coz for the new size the component requirement is not changed accordingly. Even PP master data read also not possible coz order has been partially confirmed.

[Former Member · Accepted solution]

Hi,

Are you using Bundles in Production order?

If you are just adding new grid value to production order then the component depending on the grid value automatically change as per the BOM.

Have you check yours BOM component after altering the production order qty.

Regards,

Vishal

[Former Member · Accepted solution]

Hi VIshal,

In my case there is no master data. Operations and components are manintained in order creation. I have two requirements.

1. Change the order size & qty before the execution of order.

2. Add new size grid after some operations are confirmed in the order.

In the both cases, the component requirement is not changed accordingly.

But in 1st case if only qty change, component requirement is adjusted accordingly.

Edited by: Jayakody Arachchige Hansika Kamangi on Nov 3, 2009 1:24 PM

Edited by: Jayakody Arachchige Hansika Kamangi on Nov 3, 2009 1:25 PM

[Former Member · Accepted solution]

I'm not using bundles in the production order.

[Former Member · Accepted solution]

Hi,

Then why you tried Read PP master data.

If you are assigning production order qty manually plus you are adding component manually , then you can do that after production order confirmation also. What issue are you facing .

You cannot change the component qty less then issued qty .

Regards,

Vishal

[Former Member · Accepted solution]

Hi,

The thing is always need to change the component qty. And my concern is all these are done through interface based on data from some other system. So very difficult to handle component qty changes size wise.

[Former Member · Accepted solution]

Hi,

If you are using some Z / interface for that then it wont be possible .

Only option left is to create new production order.

Regards,

Vishal

[Former Member · Accepted solution]

Tks for the reply

[Former Member]

Dear Jayakody,

As per my knowledge, ur requirement cannot be met

Regards

kumar