on 11-02-2009 3:28 PM
Folks,
I have the following requirement:
Material is subject to alternative UOM: 5 PCE = 1 PAK
Orders can be in both PCE and PAK
Because of that, ATP situation can result in partial PAK's.
Delivery for 14,8 PAK
Requirement:
TO with 1 item with 14 PAK and 1 item with 4 PCE.
I've tried MWMTO012 and MWMTO012 but both without results...Any other suggestions?
Thanks,
MZ
Hi,
I don't think we can change UOM during TO creation. TO is always in WM/Alternate UOM. You better set up PAK as Storage Unit type instead of UOM. And always create Delivery with Base UOM or Alternate UOM. This way you can split TO items based on Full pallet and partial pallet quantities and is pretty standard in WM.
Thanks
Vinod.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
used an enhancement in TO save which checks on fragments and when yes, then create a split.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
if it is that situation you can create two lineitems in the order one with PCE and one with PAC with the required qty .however system will allow to create TOs with alternate UOMs.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
110 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.