FI IDCO standard ALE configuration

[Former Member]

Hi all,

I need some help on a solution to set up for FI doc ALe ditstribution using standard tools.

The goal os is to send Acc doc from an R/3 to antoher R/3 system via trfc idoc, using standard messages, functions, ...

The acc docs should be sent 1/dya to the receiver system.

- If I activate standar FIDCC2 message , setting up ALE for sender & receiver, trfc ports, partner prof, ...

in mode immediate, .. The acc docs created in sender system will be created automatcially on receiving system ?

Is it enough or should I use an exit, BTE, .. to create the idocs ??

My doubt is here, should I add specific code to trigger the idoc creation, or it is done automatically in this case ?

Thanks for your help,

A.F

[former_member223446]

hi

if the message type is standard one,no need of write code to trigger the idoc.maintain below steps as mentioned

1.BD64->create modelview and generate.once it is successfully generated.

2.go to we19.and click on VIA MESSAGE TYPE Radibutton and press F8

and fill the control record ,then click on 'standard outbound processing' button.

it will ask receiver port partner no partner function ,don't give sender port,it is automatially detected by system.

then click on continue.

go to we02 check the status .if it is 03.success.if it is 30 go to bd87 t-code and re-generate it will come to 03 status.

let me know if you have queries.

kiran jagana

[Former Member]

Thanks Kiran,

so when FI docs are created, the documetns which cuold be dstributed according to dtribution view will be sent automatically to receiver system ?

The standard will manage itself the EDIDC, EDIDD, ... fill & creation ?

Any need to do it myself in specific ?

Thanks a lot

A.F

[former_member223446]

hi

Moderator message - Please do not ask for or offer po1nts - unassigned.

Kiran Jagana

Edited by: Rob Burbank on Nov 2, 2009 11:52 AM

[Former Member]

OK

[Former Member]

Hi Albert,

The final answer was erased by the moderator. Could you tell me what it was?

I am having the same kind of issue trying to send FI IDoc while using ALE technique. I do not know what needs to be configured in standard. At the end was it mandatory to do some specific ABAP coding?

Thank you for the answer?

Best regards,

Sylvain