Skip to Content
avatar image
Former Member

unristricted stock to qi stock transfer problem

Dear sll,

in my plant finshed goods ware activated with quality for despatch . at the time of stock transfer with movement type 311 some time stock goes to qualityy stock . but some times it didn't go to quality inspection stock (i.e. it was directly goes to unrestricted stock with the defined batch.

please give me the solution for this issue.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Oct 30, 2009 at 10:44 AM

    hi Which T code You are using for stock trnsafer ?

    I Presume that you are using 08 Inspection type ,with MB1B t code .

    Then whenever stock trnafer will happen ,it has to create Inspection lot.

    Make sure the stock type is same in all cases for Mvt type 311.

    Please revert back

    Sujit

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 30, 2009 at 10:46 AM

    Dear Madhu

    Is Quality Lot generated at each time ?

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      hi

      that what my problem some times it was created lot in quality ( i. e. stock shows in mmbe in qulaity stock) , some times it was directly goes to fgstock .

  • avatar image
    Former Member
    Nov 04, 2009 at 12:56 PM

    Hello Madhu,

    have you maybe set a DMR and a Dynamic Modification Level to the plan?

    Take a look at the Plan header or in Process plans look at the QM data in the header.

    Usually if you have set up something there you would get that behaviour.

    Another thing you could check is if you have maybe assigned different plans for the ammount produced and if maybe an Inspection characteristic is assigned to one of these plans. Control key QMnn.

    In this specific case I would need more information.

    Regards

    Isabelle

    Add comment
    10|10000 characters needed characters exceeded