Firefighter - SoD Violations Report - not showing any data

[Former Member]

We have ECC6 and GRC 5.3 with latest patch. Our RAR is working well also. We recently installed firefighter. All reports are working fine except following two reports,

1: SoD Violations Report

2: Critical Transactions

We want to use RAR critical table and SoD data, therefore In our configuration table we have following paramter set as:

Critical Transaction Table from Compliance Calibrator (VRAT) = YES

Could someone please direct in right direction how to get it fixed. Is there any SAP Note suggesting configuration setup etc.

Thanks in Advance

Masood Akhter

[Former Member]

Hi,

Did you do risk terminator settings in backend and given the same details in RAR connectors and then adapter activation.Please see the below NOTE.

SAP Note 1055976 - Firefighter 5.X - Unable to run the SoD analysis report

Thanks,

Joseph

[Former Member]

There are a number of settings to be made in order to get this working. The note is helpful but effectively you need the following:

In ECC

TCP/IP RFC Dest created with a unique report name.

This RFC mentioned in the /VIRSA/ZRTCNFG transaction

In RAR

The Report name entered into the RAR connector.

The SAP gateway mentioned in the RAR Connectior.

The RAR connector marked as outbound connection.

The SAP Adapter activated.

In SPM (ECC)

Set the "Connector ID for Risk Analysis" parameter to the name of the RAR Connector in the SPM configuration table.

You may also have to do a Java system Restart if you encounter error messages when activating the SAP adapter in RAR.

Simon