Single recording

[Former Member]

hi experts,

Can any one help me in the following,

during result recording(single recording), after entering the results the system itself valuate and put the mean value for results. Based on this value system accept the characteristics. How the system calculate the value, from where it get the formula.But in this sample size out of 5, 3 samples are not within the limits. I want the system to calculate the lower and upper limit value for accepting the character.

Waiting for your reply

GM

[Former Member]

Closed

[Former Member]

Hi,

The result valuation rule comes from valuation mode of your sampling procedure. Use valuation mode " value within tolerance range" or as per your requirement.

[Former Member]

hi dinesh,

its not working. It calculate the mean value of results only. can u please brief it.so that i can try it.

muthamil

[Former Member]

Hi Muthamil,

In your sampling procedure (QDV2) there is a provision for valuation mode. In that use " Mean value with in tolerance range" or "manual valuation". It should work.

I think my understanding is correct. If not please give your scenario & examples exactly.

[Former Member]

hi dinesh,

In result recording the sample size is 5 and Sampling type is Fixed , Valuation mode mean value with tolerance range. when i enter the 5 values and click the valuate button system itself put the mean vale. But i need the system to consider the Higher and Lower value and enter the mean of two values.

G.M.

[Former Member]

Yes Muthamil,

Got your requirement. For this you need to create a calculated characteristics. By using an opt formulae, you can acheive this. There are predefined formula parameters. Am not in front of system. So from memory am saying your formula would be (B9.....+BA.....)/2. But am not sure. Please cross check.

[Former Member]

hi dinesh,

I tried but it is used for, if the inspection result for an inspection characteristic is not determined through the inspection of this characteristic, but on the basis of calculations using the inspection results of other characteristics within the same operation.

muthamil

[Former Member]

Hi,

Its all about your "MERKNR" value i.e. inspection plan characteristics number. If the calculation is within an operation, then no issue. I couldn't get your exact struckups.

[Former Member]

Hi Dinesh Krishnan,

I couldn t understand. please explain me in brief.

Muthamil

[Former Member]

Hi

Check the sampling procedure

What is the Valuation mode you have selected?

depending upon the valuation mode system draws the acceptence or rejection.like of you have selected mode as"Mean value & tolerence ragne " system will do valuation on mean value.

Regards

Suji