Skip to Content
avatar image
Former Member

Error during start of process in Inegration Process

Hi,

My scenario is file to integration process and back.

Message is not entering my integration process. In sxmb_moni it shows a green falg at the queue and when you click on 'PE', we are taken to the inbound queue with 'SYSFAIL'.

The error description at the trace is 'Error during start of process'.

There are no errors in sxi_cache for the particular integration process. The return code is '0'. I have tried re-activation too and tested again. But to no avail.

There are no entries in swwl, since the message has not even entered integration process.

Kindly help me to correct the error.

Thanks,

John

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Oct 12, 2009 at 08:06 AM

    Hi John,

    As there is some error in configuration, message is not entering your IP,

    and you see green flag which means the job is scheduled and if you go to SMQ2, the message is stuck becasue of error.

    Have you used any mapping between sender an IP?

    If yes, check that and also check your configuartion in ID.

    Regards,

    Supriya.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 12, 2009 at 08:23 AM

    Recheck all your steps inside the BPM.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 12, 2009 at 11:25 AM

    Hi John,

    Check one more time your ID configuration, and also the BPM.

    If both of them seem to be fine, then check cache.

    If there is no problem, then try reimporting your BPM from IR to ID and then try again.

    Regards,

    Supriya.

    Add comment
    10|10000 characters needed characters exceeded