Skip to Content
avatar image
Former Member

Credit management

Dear All, Good morning

I hope you all doing good.

We have vendor as customer.

In the credit management can we able to consider vendor payable amount in the credit limit while creating sales order for that Vendor.

For Example:-

I have procured material from Vendor A for Rs 100000

Credit limit for that Customer-A(vendor as customer)--Rs 100000

Now system should allow credit limit for that customer Rs 200000 ,more than that system should not allow.

-->One more requirement is can we activate credit management only for selected customers ! (i.e vendor as customer)

Kindly reply with your inputs ASAP

Regards,

Murali.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Oct 10, 2009 at 04:38 PM

    I dont think, through standard configurations, this is possible. Perhaps, you can try with any of the following Credit Check User exits.

    a) LVKMPFZ1: USER_CREDIT_CHECK1

    b) LVKMPFZ2: USER_CREDIT_CHECK2

    c) LVKMPFZ3: USER_CREDIT_CHECK3

    thanks

    G. Lakshmipathi

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 10, 2009 at 02:07 PM

    Hi,

    Through standard system settings you cannot do it.In credit management config there is a option of user exit also,you can check that option and take the help of ABAPER and try to mke your logic to take the customer as well as vendor amount for credit limit.

    You can make Z-table where u can put the refernce of Vendor agianst each customer number sothat in user exit it will carry the balances from both customer and vendor.

    Regards

    Sunil

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 04, 2010 at 10:54 AM

    Thanks

    Add comment
    10|10000 characters needed characters exceeded