10-10-2009 5:45 AM
Hi experts,
My requirement is User should not create material with out units of measure in additional data.
User should maintain un(units for all finished material). I maintain this control based on sales organisation. kindly provide BADI / USER EXIT.
Thanks & Regards
G.Vendhan
10-10-2009 8:25 AM
Hi G.Vendhan,
Ask the functional consultant there to check out in below FM if they can make it possible through it...
OMS9
Hope it will solve your problem..
Thanks & Regards
ilesh 24x7
ilesh Nandaniya
10-10-2009 8:25 AM
Hi G.Vendhan,
Ask the functional consultant there to check out in below FM if they can make it possible through it...
OMS9
Hope it will solve your problem..
Thanks & Regards
ilesh 24x7
ilesh Nandaniya
10-10-2009 12:35 PM
Hi ilesh,
I want to control for particular sales organisation and materail type, is it possible in OMS9
.
Thanks and Regards
G.Vendhan
10-10-2009 1:56 PM
hi right now i donot have system with me.
But i remember a exit MGA00001 for checks in MM01.
Check whether its applicable.
Just keep a break-point in * CALL FUNCTION 'SXV_ADD_PREFIX' * of function module SXV_GET_CLIF_BY_NAME.
Run your transaction MM01.
Check the exporting parameter name of the function module.
It will give you the BADi names used in MM01.
10-10-2009 2:06 PM
Hi Vendhan,
For your requirement of checking material master fields, while saving. we have a BADI to solve your requirement, Try to impelement BADI_MATERIAL_CHECK. This gives access to check all fields before material master creation or changing.
Best regards,
Kumaar.S
04-20-2023 2:26 PM
12-22-2009 10:22 AM