Issues in IDOC to File scenario using bussiness service

[former_member209912]

Hi Team

I found a blog which explains about the IDOC to FILE scenario by using bussinss services. I followed the steps and finally i am getting a error message while posting an idoc in we19 (ie IDOC 09878 was saved but cannot or should not be sent). The setting which have done on SAP side are as below

SAP SIDE CONFIGURATIONS

1. Created RFC destination : RFC_XI_SYSTEM

2. Created port : PORT_TEST

3. created logical system: IDOC2FILE

4. created partner profiles: IDOC2FILE

XI side configurations

1. Created RFC destination: RFC_SAP_SYSTEM

2. Created port : by using IDX1 t-code

DOUBT: here it is asking for PORT, CLIENT,Description and RFC destination, please let me know what values i need to put here, please find the SAP and XI system details below and suggest accordingly.

3. metadata: by using idx2.

DOUBT: here it is asking for IDOC type and source port, i can give the idoc name but i am not getting what i need to give to source prort field, please check and let me know, please find the SAP and XI system details below and suggest accordingly.

SAP system details

Client: 800

User name: sapuser

system id: DEV

system number:10

XI system details

Client:100

username:xisuper

system id: SXI

system numebr: 00

I request you to please check and help to successfullly completion of this scenario. I request you to please provide me the screen shots of the pre-requiste settings and suggest me the steps to debug the scenario.

Thanks in advance.

Raju

[Former Member · Accepted solution]

IDOC 09878 was saved but cannot or should not be sent - In order to debug this, you will need to go to we05 and check what the actual error is.

Apart from that on the PI side in idx1 on creation of a new port, you would need to give a name relative to the ECC system from where the IDOC is coming from. i.e., Name SAPDEV Client 800 RFCdest name of one created on XI that points to the same ECC system.

In idx2, give the port name created in idx1, i.e., SAPDEV and the IDOC type to extract the meta data.

On the SAP side it looks like you have not configured the inbound/outbound parameters. They should be configured for the IDOC to deliver.

Good luck!

[Former Member]

To complete your scenario successfully with better understanding of Idoc adapter

read http://help.sap.com/saphelp_nw70/helpdata/en/ab/bdb13b00ae793be10000000a11402f/content.htm.

for troubleshooting refer http://help.sap.com/saphelp_nw70/helpdata/en/6a/e6194119d8f323e10000000a155106/content.htm

[prateek]

In XI, create a port using RFC destination with name SAPDEV where DEV is Sys ID of your SAP system. This SAPDEV should then be used in IDX2.

Your sender and receiver partner details seems to be incorrect and therefore you are not able to send Idoc. This could be mistake in we19 itself.

Regards,

Prateek