Values not printing in Certificate from Inspection Points

[vineeth_varghese]

Hi,

I have created certificate profile for 2 characteristics in inprocess inspection with inspection points and I assigned origin and insp type as 03.

I also did assignment of material to certificate profile. Then when I try to create certificate for inspection lot with 03. It is only printing characteristics and tolerances only. Values for the inspection points are not getting displayed in certificate.

Thanks

Vineeth

[Former Member · Accepted solution]

{{I have created certificate profile for 2 characteristics in inprocess inspection with inspection points and I assigned origin and insp type as 03.

I also did assignment of material to certificate profile. Then when I try to create certificate for inspection lot with 03. It is only printing characteristics and tolerances only. Values for the inspection points are not getting displayed in certificate.}}

Hi Vineeth,

Pl do as follow and try,

1. Create cretificate Profile with layout QM_QCERT_01.

2. Assign MIC , which you want to print certificate-

-take result selection level as- Mean value of sample /Insp Point

Result Origine - Inspection result

Regards,

Neeraj

[vineeth_varghese]

its working

[former_member186399]

Dear Vineeth

In certificate profile try to put in characteristic > Result selection level > 2 mean value of the sample / inspection point and check

Regards

Gajesh