on 09-21-2009 4:57 PM
Hi all,
I am on 3.5. I have added a z-attribute to 0MAT_PLANT, an existing master data infoobject. I added it, and then wrote a transfer rule in ABAP to fill it. However, a problem arises when I try to load it. I run a full load of 0mat_plant. It is successful (RC = 0), but no records are added or changed - which I guess makes sense because the data set I'm loading from R/3 hasn't changed. However, this resents a problem because my new attribute is not populating. How do I trigger a load that fill my new attribute?
Thanks.
Dave
Thanks anyway...figured it out...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi there,
It seems you're sending your data from R/3 to 0MAT_PLANT with delta, therefore, if no new data, nor changed data is present in R/3 you wont' have any in BI.
Just do a full load of your R/3 data to the 0MAT_PLANT in BI to completly fill the 0MAT_PLANT (and therefore filling the new field), after that you can continue to have to normal delta data, that for every new record or changed record to 0MAT_PLANT will be filling again the new attribute, but you have already completly filling the "old" data of 0MAT_PLANT (with the full) with the new attribute data.
Diogo.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.