Skip to Content
avatar image
Former Member

Business system does not have inbound,outbound interfaces in ID

Hello All,

I created one business system in SLD and i imported That Business system into ID.

But when i am opening the Business system in id, it does not have any sender and receiver interfaces.

I checked in SLD, as of my kowledge BS configuration is correct.

In ID i did cache Refresh also. Tell me how can i achieve this thing.

Thanks,

s.k.prabhakar.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Nov 19, 2016 at 09:54 AM

    Hi Prabhakar!

    Since your interfaces are bound to Software Component Version in ESR, you should check if according Product and Software Component is assigned to Business System in SLD.

    Regards, Evgeniy.

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 19, 2016 at 09:46 AM

    Hi,

    Did you create Technical system on Product that you created for this system or not? And is there any interface you made under that Software Component or not under same product?

    If your answer is no, then do it now.

    If yes, then clear all cache. If still facing this issue, then double click on BS in ID and add any Receiver or Sender Interface by clicking on add interfaces for both receiver and sender.

    Hope it help you.

    Regards,

    Anoop Kumar Rai

    Add comment
    10|10000 characters needed characters exceeded

    • Hi,

      One more thing i want to add in above is that, if you open display Business System in ID. There is a tab called "Other Attributes". Just check whether your Software Component display here or not in Software Components list.

      Regards,

      Anoop Kumar Rai

  • Nov 21, 2016 at 02:55 AM

    Hi,just as Rai said,after you imported the BS in ID and actived it,double click on the BS,add the inbound interface in the Receiver,save and active the BS again. Then continue the configuration,you'll find the interface you want to use in interface determination or intergration configuration.

    Add comment
    10|10000 characters needed characters exceeded