Application Development Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Reg: PO interface from 4.7 to ECC 6.0

Go to solution
Former Member

‎09-16-2009 12:23 PM

0 Kudos

Hi Everyone,

I'm new to ALE/IDOC, Can anyone give the steps which needs to be followed to send POs thru IDOC from 4.7 to ECC 6.0.

Do I need to populate all the data like control segments, data segments or PO related details will be sent thru IDOC if we pass a particular details of that PO?

Pls give me some tips to proceed...

1 ACCEPTED SOLUTION

Go to solution
Former Member

‎09-16-2009 11:51 PM

Hi,

You can use the IDOC Type: ORDER05 for this PO reqt. For PO the 850 EDI is used.

You need not fill in all the data for the segments, but only the mandatory fields & segments and along with some header details like Pur Org, vendor No, plant etc.

Based on some of the mandatory parameteres you fill in, it will be validated with the config already done in the SAP system.

Pls got to WEDI (Adminstrator Menu)- type it as a T-Code and you can go thru the details.

Apart from this the RFC destination needs to be set up in SM59 and the logical system settings in WE20 along with the port settings in WE21 has to be carried out.

Hope this helps.

thanka

JLN

1 REPLY 1

Go to solution
Former Member

‎09-16-2009 11:51 PM

Hi,

You can use the IDOC Type: ORDER05 for this PO reqt. For PO the 850 EDI is used.

You need not fill in all the data for the segments, but only the mandatory fields & segments and along with some header details like Pur Org, vendor No, plant etc.

Based on some of the mandatory parameteres you fill in, it will be validated with the config already done in the SAP system.

Pls got to WEDI (Adminstrator Menu)- type it as a T-Code and you can go thru the details.

Apart from this the RFC destination needs to be set up in SM59 and the logical system settings in WE20 along with the port settings in WE21 has to be carried out.

Hope this helps.

thanka

JLN