Skip to Content
avatar image
Former Member

Issue on printing LETTER Format

As a newer in form print. I copied WASCHEIN to ZWASCHEIN, and reset the Pageformat to LETTER . Then after editting the height and width of the windows, I actived the form successfully.

But when I use this form ZWASCHEIN in WA03 to print Material Document by tcode MB02.

After I saved the message, here raise an error "load plain A4 paper" in my printer , until I go over and tell it to change the paper and print it on letter paper. My printer only has letter paper and does not take any other kind. And I checked the request number in sap spool by tcode SP02. The format of my request is LETTER too.

Should some further settings be done for this issue ?

Hope for your answers! Thanks !

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Sep 10, 2009 at 06:16 PM

    Did you check if the custom form has been changed to a letter format, as I too faced the same thing, when the form shows a letter format in the basic settings, then it has to go through

    Add comment
    10|10000 characters needed characters exceeded