cancel
Showing results for 
Search instead for 
Did you mean: 

0ASSET_ATTR

Former Member
0 Kudos

Hi,

We are trying to load masterdata for 0ASSET_ATTR. We are getting no data but the status is green and no idocs are transferred to BW.

Also we suspect that there is some change to the data source which we are not able to trace in documentation.

Inputs are highly appreciated!

Br.,

Venkat Ambati.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi there,

From what I remember you first need to extract 0ASSET_AFAB right?

Diogo.

Former Member
0 Kudos

I dont think so. i see no dependencires with that.

Former Member
0 Kudos

Ok,

Sorry my mistake, is the other way arround if you extract data with delta with 0FI_AA_11 and 0FI_AA_12.

Nevertheless, you're saying you're not getting data. Full or delta? What about RSA3 in R/3 side? Does that bring any data?

Diogo.

Former Member
0 Kudos

Dear Diogo,

This is full update of master data. I see that its not pulling even in RSA3.

Former Member
0 Kudos

Hi there again,

So with RSA3 with full (and no selections) you're not getting any data (but you were before), try as suggested save the datasource under transaction RSA6.

Did you install any support packages recently in your R/3 side, any upgrade?

It seems something messed up your datasource. Maybe look for OSS notes.

Diogo.

Former Member
0 Kudos

Well, I am investigating in the same direction. Thankyou for the support! Will get back with my findings.

Former Member
0 Kudos

Ok,

Search OSS notes with 0ASSET_ATTR_TEXT.

I found 21, see if any of them applies to your situation.

Diogo.

Answers (2)

Answers (2)

dennis_scoville4
Active Contributor
0 Kudos

There are a couple of things to take a look at:

1) Was the FIAA_BW_DELTA_UPDATE BAdI activated in your source R3/ECC environment? If not, go to SE19 in your source R3/ECC environment and activate it.

2) There is a sequence that you must be followed for extraction of Asset Accounting data. The sequence must be: 0FI_GL_4 (if you're using this DataSource), 0ASSET_ATTR (or the newer and recommended 0ASSET_ATTR_TEXT DataSource), 0ASSET_AFAB, 0FI_AA_11 and finally 0FI_AA_12.

former_member207028
Contributor
0 Kudos

Hi Venkat,

check the data source at RSA3 in source system for data records.

if data source is active and fetches records at RSA3, source system side data source 0ASSET_ATTR is ok.

then install again this datasource from RSA5, if data source 0ASSET_ATTR is not enhanced, if enhanced check the code and run at RSA3.

Best Regards.

Edited by: Daya Sagar on Sep 9, 2009 11:52 AM