on 09-07-2009 10:38 AM
Hi,
i have a simple (MQ2IDOC) interface, following new user request i have to integrate additional receiver (mail) which will notify a selected user that idoc was sent.
solution was quiet simple, by adding additional "entry" at Receiver Determination --> Configured Receivers --> service. it works just fine (mail is being send whenever interface is being used). yet, i must tune the mail receiver so it wont use its message payload/content, since all i need is an empty mail (only subject; e.g. "idoc was sent"). how can it be done?
Regards
Uri
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.