Skip to Content
avatar image
Former Member

Clix for Master-Slave Synchronisation

Hi SDNers,

I am using the Slave and Master reposirotries. If anyone has used CLIX for the Master-Slave synchronisation, please give the related commands. File would be of greater help.

Any suggestions are also welcome.

Thanks & Regards,

Priti

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Sep 01, 2009 at 04:22 AM

    Hi Priti,

    For synchronization use the below command

    CLIX repSynchronize MDMHostSpec slaveRepositorySpec Credentials [-D]

    Related commands:

    CLIX repSwap MDMHostSpec stoppingRepositorySpec swapinRepositorySpec [-D] [-W]

    CLIX repShare MDMHostSpec RepositorySpec Credentials [-O][-D]

    You can get the list of CLIX Commands here

    http://help.sap.com/saphelp_mdm550/helpdata/en/8e/9f9c427055c66ae10000000a155106/frameset.htm

    CLIX Command Line Interface -> Command Detail

    Use of commands is completely depending on your business requirements.

    Regards,

    Jitesh Talreja

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 01, 2009 at 07:57 PM

    Hi Priti

    Copying from help.sap

    Sharing and Swapping Slave Repositories

    You can use the repShare command to make a slave repository u201Cshareableu201D so that multiple MDM Servers can load it. Conversely, you must use the repExclusive command to return the slave to an unshared state before synchronizing it, so that a single MDM Server can issue the synchronization command.

    An alternative to this methodology is to leave the single slave shared and loaded, and then:

    ...

    1. Create a new slave from the Master.

    2. Make that new slave u201Cshareable.u201D

    3. Load the new slave without ports in the background using the repPreload command on each MDM Server that acts as a host.

    4. After each host completes the background load, use the repSwap command to swap the new slave for the old on the same port.

    for more details refer to relevant sections in help.sap.com

    best regards

    Ravi

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hello Ravi,

      We are investigating the use of repPreLoad and repSwap with MDM 7.1 and the commands no longer appear to work with Clix (7.1.03.62). If I use one of those two clix commands, clix behaves as if the command doesn't exist. Typing clix r at the prompt (which lists the repository commands available) shows a list of commands with these two missing. Has SAP decided to remove them?

      Paul

  • Jun 06, 2010 at 11:21 AM

    Closing thread

    Add comment
    10|10000 characters needed characters exceeded