on 08-26-2009 4:01 PM
Dear Guru
when ever an usage decision is made , a pop is sceen " Evaluate the no valuated characteristics" I got to click on YES or NO to continue further.
Is this part of standard config setting where i can go and remove it so that i dont see the pop up any more
or
Is this part of work flow or custom development.
Thanks in advance
Nithi A
Hi
a pop is sceen " Evaluate the no valuated characteristics
If you do not want to do Result recording then go to QM view >select inspection type>remove tick og check char
this msg will not appear.
or
valuste all char ( status :5)
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
a pop is sceen " Evaluate the no valuated characteristics
If you do not want to do Result recording then go to QM view >select inspection type>remove tick og check char
this msg will not appear.
or
valuste all char ( status :5)
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
>
> when ever an usage decision is made , a pop is sceen " Evaluate the no valuated characteristics" I got to click on YES or NO to continue further.
>
> Is this part of standard config setting where i can go and remove it so that i dont see the pop up any more
>
> or
>
> Is this part of work flow or custom development.
No this pop-up is not part of work flow.
You are getting this message because you have not done valuation/ RR for all MIC. Few MIC are still there for lot without valuation.
To avoid message during UD just make sure you have done RR & valuation for MIC of lot. All MIC are closed with status 5 in lot.
Hope this helps.
Thanks!!!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Nehal
Thanks a lot for your response.
In my case a lot normally has almost 100 characteristics. But mostly only 35 characteristics values are entered / calculated. So i cannot enter values for all these characterisitcs.
So given the case how can i avoid that pop up from coming when i do my UD, even if most of the characteristics does not have a status 5.
Thanks.
nithi
Hi Nithi,
As per your requirement the 35 operations that you are testing you can set to a required characteristic within the control indicators for the MIC, the other operations that you do not require to enter results you can set these as optional characteristics within you control indicators. This should prevent the pop up screen.
Regards,
Roderick
User | Count |
---|---|
103 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.