BOM

[Former Member]

Dear all,

i have checked for one matreial BOM

and intreatingly found that

A- semifinshed HALB (at top level)

under this A i have

B - ROH

C - Finished (FERT)

under C again i have

D - ROH

E - semifinshed (HALB)

under this E i have

F - ROH

G - ROH

Kindly share ur views

Regards

kumar

[Former Member · Accepted solution]

Hi,

Investigate the BOM from business perspective & check if the BOM has been setup correctly. If that is fine, then check why C has been defined as FERT & A as HALB.

It could be that C is sold as a finished goods & at the same time is a sub-assembly for another higher assembly (A).

Regards,

Vivek

[Former Member · Accepted solution]

Thanx Vivek,

above A, i have another material which is FERT

but rest of sequence i mentioned is same

just confusion is under HALB there is a FERT

Now as a consultant what should i do

Plz suggest

Regards

kumar

[Former Member · Accepted solution]

Hi,

What you notice is quite possible to occur as one finished product can be a part of another assembly.

As said earlier look at it from business perspective. Check & ensure the FERT which is under the HALB is truly a finished product which your client manufacturers & sells.

Also check if you can change the material type of FERT to HALB, discuss with your business contact point to understand this assembly.

Regards,

Vivek

[Former Member · Accepted solution]

Thanx Vivek,

will check & close the thread

Regards

kumar

[Former Member · Accepted solution]

Thanx Vivek,

i checked for many materials

sequence is same as i mentioned

under HALB there is one FERT

will check with the client & get back to u

as of now closing the thread

once again thanx a lot

Regards

kumar

[former_member196398 · Accepted solution]

Kumar,

Which company you are working with and whose is your current Client? You can mark this answer to my E-Mail Id.

I think if many FERT Materials are assigned to HALB, then it seems logically wrong..FERT can get assigned to FERT..Please check with your client on the business process and see whether they are mapped properly.

Regards,

Prasobh

[Former Member · Accepted solution]

Dear Prasobh,

many materials means,

i have checked for 10 FERTs in CS03

all this ten Fert's are having HALB's under them

and again under that HALB i can see one FERT

anyways will give full clarity in coming days

Thnax for replying

Regards

kumar