on 09-20-2018 9:38 PM
Hi All,
I have set up partner determination via IBASE for ZMCR to automatically assign the Change Advisory Board partner function.
After the cycle has been selected and the component defined after scope is selected, the partner gets populated correctly only when in "Created" status and selecting the action to set to "Validation" status. If selecting the scope and component in "Created" status and selecting "Save", the partner does not populate (even if updating to "Validation" status afterwards). Also, if waiting to populate the scope and component until after already in "Validation" status the partner does not populate.
Is there a way to correct this via configuration? Any feedback would be appreciated.
Regards,
Paul
Dear Paul,
Your question is unclear. Can you list down the actions you are performing in sequential points for both the cases and explain?
Regards,
Shalin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.