Tax code

[Former Member]

Dear All,

We have used same taxcode but different two plant as Inventorized & set Off.

One plant is Set off & second plant is inventorized, we used FV12 for Taxcode same as VA which is alreay used (for Condition type Jmop) now i want same tax code Jmop & Jmip for plant wise.

i maintained this in FV12 but condition type is comming Jmop & Jmip both are actually we require onlyJmip.

Please guide me.

Thanks

Shital

[Former Member · Accepted solution]

Please create or use Access Sequence Plant / material / Vendor so as the plant changes the value in condition type will be different as required by you.

Regards

Bhavesh Mistry

[Former Member · Accepted solution]

Dear All,

I checked Access Seq but not resolved.

Thanks

Shital

[Former Member · Accepted solution]

at what level are u mainatining the condition. normall the excise condition are mainatined as plant/vendor/materials. which excise sequence r u using in jmip?

[Former Member · Accepted solution]

Dear Amit,

I maintained this Tax code as Plant & Material Group wise, in JMOP & JMIP.

Tax code is alreay used & we maintained condition type JMOP for only Tax code Combinition, now use this Tax code we required Two plant wise so we maintained this in Plant & Material group wise combination, its working in one plant & second plant Two condition are calculating, JMOp & JMIP but we require only JMIP.

Please guide me

Thanks

Shital

[Former Member · Accepted solution]

Maintain all the conditions at plnt and material group. remove the condition which u have maintained at tax code level. In u case for second plant as u have not maintaine the 0 value condition for jmip at plant/material group level it is picking vaule from tax code level.

So either mainatin 0 value condition for jmip where u don't want or mainatin all the conditions at plant/material group and delte all the conditions at tax code. this will solve u r proble.

[murugan_mgl · Accepted solution]

HI,

Goto FV13,enter JmoP,give the plant /matl grp& then see whether this condition is existing in for the inventorized plant.If it is existing in this plant then select the condition & goto the top & click on change.Then delete the condition & save.then check in the PO it would have dissappeared.

Edited by: Murugan mgl on Aug 14, 2009 8:50 AM

Edited by: Murugan mgl on Aug 14, 2009 8:51 AM

[Former Member]

hi sheetal

Check ass. sequence of cond, and use key comb, plant/ matrl/ vendor or plant/ mtrl grp.

Vipin