Skip to Content
0

Failed to call the endpoint: Error in call over HTTP: HTTP 200 OK - AFW_ERROR - SEND_TRANSMIT_ERROR

Nov 17, 2016 at 05:32 AM

664

avatar image

Dear All.

My scenario is File to SOAP using (XI3.0 protocol) pass-through. and we are sending CSV file by using above scenario.

in target SOAP Adapter we maintain the URL as

http://taregethost/port/XISOAPAdapter/MessageServlet?ximessage=true.

target system also has PI, and we are adding header mapping well.

Issue:

we do have 2 scenario pass-through as mentioned above, but one scenario is working file another scenario is failing in PI end.

  • The important part is: target system receiving the file from both scenario, but only one scenario getting failed at PI end

when i take an xpi trace i found below error

and the successfully working scenario's xpi trace

we cross verified , bothe 2 scenarios are same, only header mapping is different.

please do needful.

Regards

Ramesh

1.png (75.8 kB)
2.png (66.7 kB)
10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Evgeniy Kolmakov Nov 17, 2016 at 06:12 AM
0

Hi Ramesh!

Do you receive message on target side?

Regards, Evgeniy.

Show 7 Share
10 |10000 characters needed characters left characters exceeded

HI Evgeniy..

Thanks for your reply

Yes you are right.. target system receiving the file from both scenario, but only one scenario getting failed at PI end

0

Please check if your receiver SOAP adapter is in EO mode (and receiver inbound interface is asynchronous).

0

Shouldn't the Message protocol be HTTP because XI 3.0 is used when u r intercating with ECC system if i am not wrong.

1

You're right, I missed that. Transport protocol is HTTP and message protocol is XI 3.0.

Regards, Evgeniy.

1

HI Evgeniy..

Thanks for your reply..

Yes, the Transport protocol is HTTP and message protocol is XI 3.0. and the scenario is pass through, but the service interface is available in ESR as asynchronous mode .(note: we didn;t call operation mapping in ISO we only call receiver SI and namespace).

can you please suggest further.

0

Can you confirm that there are no errors during message processing at receiver's side. Can you check for any errors on ABAP side?

Regards, Evgeniy.

0
Show more comments