Skip to Content

Quality Inspection in WM

Dear All,

I have 2 questions:

1) I want to receive materials under quality inspection during MIGO. How? I only managed to do it by entering Q at the PO.

2) After receiving quantities in quality inspection, how to transfer them in Unrestricted in WM?

best regards

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Aug 17, 2009 at 04:02 PM

    hi

    here is the process.

    For a Material with Inspection setup in QM view of material

    master.

    step1

    The moment you post GR , the stock will be received into QI

    status in IM

    and in WM stock will be under storage type GR Area External

    Rcpts Q status .

    Step2.

    Using LT06 create a TO for the Material document

    IM stock will be in QI status

    WM stock will be under selected storage type (during TO

    processing ) in QI status.

    step3.

    Then complete the usage decision against the Inspection lot using

    QA32.

    movement type 321 is triggered and stock moves from QI to

    unrestricted stock in IM.

    step4.

    Confirm the TO created in Step 3.

    step 5.

    create a TO against PCN created in Step 3.

    and confirm.

    Stock will be in unrestricted status , available stock in WM.

    Since you are saying that stock is in Q status at WM level.

    pl. check if any PCN, TO is open for the Material

    and try to close those by either creating a TO against PCN - LT05

    or confirm if TO exist by using Lt12.

    Thanks

    Prasanna

    Add comment
    10|10000 characters needed characters exceeded

    • So basically, after creating the TO base on the RCN the material is ok. i am asking because in the quality storage are i see in that bin the material qith quantity and at the destination bin the material appears with quantity zero "0". i thought it will change the previous line that has Q indicator and appear the same line without Q.

      Regards

  • Aug 04, 2009 at 06:18 AM

    Hello,

    If u refer some of the earlier threads I believe I answered this question.

    After GR system will create inspection lot .This inspection lot will be clear & system will create PCN with 321 movement. This PCN has to be converted into TO.

    Regard

    Prashant

    Add comment
    10|10000 characters needed characters exceeded

    • Dear Prashant Dhakane ,

      If it is possible, please specify the links of this threads. I did not find any. Also PCN? I am trying to make 321 Mvm type but the system shows deficit stock although at MMBE it shows stock at quality.

  • avatar image
    Former Member
    Aug 03, 2009 at 05:57 PM

    If the material master is defined for quality inspection creation , it would automatically create the QI lot for MIGO, and for receiving the stock into unrestrcted you can do the posting change with MB1B or release the stcok from the quality.

    Add comment
    10|10000 characters needed characters exceeded

    • Dear York, Thank you for your answer. I have maded MB1B movement, but when i display the storage bin i still see the material with Q indicator. Isn't MB1B an inventory movement? How WM is reflected?

      Regards