Skip to Content
avatar image
Former Member

Changes to key figure settings

Dear All,

In SCM 5.1 if I change the decimal settings of the key figures in the initialized planning area, is it necessary to replicate the planning area datasource also?

Regards,

Kedar

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Jul 30, 2009 at 11:21 PM

    Hi,

    If you want to see the data in to planning book then no need to change the decimal places in the planning area. Just go to design of planning book..right click on the key figure & change the decimal places setting..

    If you change the setting in to planning area then test data source first, if you find the data without decimal then no need to replicate it..Try this in development first then go for production.

    Regards

    Sujay

    Add comment
    10|10000 characters needed characters exceeded