Default packing output type selection in Delivery

[Former Member]

HI,

I have created a packing output type - ZTPL, I have done all the normal configuration like output procedure and condition record maintained and so on..

But in delivery process, every time I need to select packing output type manually like as below..

Delivery -> Extras->Delivery Output->Header -> ZTPL and save.

My requirement: Default packing output type (ZTPL) selection for delivery.

Kindly help me on the above requirement.

Thanks

Regards

Suresh.

[Former Member]

I have checked all the above said settings, still the problem exists.

But c. table field is only Shipping point - is there any issue if I select only shipping point.

Because other existing output types with delivery type & sh.point combination is working fine.

[Former Member]

Hello All,

Thank you all for your replies.

The above said configurations are correct.

Reason for the problem is, in output type "Access to conditions" was unmarked.

[Former Member]

Hi ,

Check the requirement assigned to Output type in Output procedures (V10000). In requirmeent it may define that Output would determine after Post good issue of the delivery document.

Hope it would help

Regards,

Devendra

[Former Member]

Hi ,

Check the requirement assigned to Output type in Output procedures (V10000). S

[former_member315051]

Create Condition records in TCode : VV21 and check.

[Former Member]

Hello Ramesh,

Condition record maintained.

[former_member315051]

check this thread , it may help u to check packing out put

[Former Member]

The given thread only talks about how to print the packing list.

I have done all the standard configurations like... output type for packing, output procedure, condition type & condition record.

but output type is not picking by default into the delivery, every time I need to pick the output type manually...

Please help me on the above.

Thanks in advance.