notifications

[Former Member]

Hi, in my case i received a mat from vendor, dimension is over size, so ud is rejected. in qm11, i could not see notification generated for this defect. is there any setting required in spro? pls advise how to view the notificaton generated and what setting need to be done?

[Former Member · Accepted solution]

Hi

In QM10 -->enter the material >select all notifications which are incomplete status>OSNO

execute

you will get list of all notifications for that material number.

If notifcation is not generated then

QCC0->Quality inspection>Inspection lot creation->Define Inspection type>select inspection type 01-->check default notification here is it active

Check here F2 type ia maintain or not.

if it is active then notification will be generated otherwise not.

Regards'

Sujit

[Former Member · Accepted solution]

This message was moderated.

[former_member587434]

What is the status of Notification & what filter data you are entering to select QN in selection screen of QM11?

[Former Member]

Hi, thank u, in-process qn is ticked, resposible etc selection was removed. i hope it shouls select allnotifications generated?

[former_member587434]

First understand status of QN.

Once you create new QN then system will create QN with status OSNO - otstanding

Once you release QN & start to work on task of QN then system will update status as NOPR - In process.

Once you complete QN then system will put status to as NOCO - complete.

Here in your case QN status would be OSNO & you are selecting in process checkbox, b'se of this you are not getting your QN in QM11 list.

Please check QN status & confirm.

Thanks!!!