Skip to Content
avatar image
Former Member

Issue in transaction LU04

Hello Experts,

We are facing an issue in transaction LU04 when we enter the warehouse number & press enter system pops below error message.

can you please guide as to what might be the reason for the error message.

Regards,

Gopal

capture.jpg (26.5 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

6 Answers

  • avatar image
    Former Member
    Nov 16, 2016 at 02:48 PM

    Thanks Jurgen will take care in future.

    Could you please help me with the error i am facing in transaction LU04.

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 16, 2016 at 03:12 PM

    Do you have EA as alternative unit in your material masters Additional data?

    Do you have a WM view for your warehouse at all.

    How are the settings for the fields WM unit and Proposed UOM frm mat?

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 16, 2016 at 07:09 PM

    As suggested by Jurgen, check the alterntive unit in Material master additional data, This error is basically due to MEINH value not defined / maintained or not available in Material master,

    If all the master data are correct and still you face issue then take the help of development team and ask to let you know what is wrong in below code

    capture.jpg

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 17, 2016 at 11:41 AM

    Hello Experts,

    For the materials the base unit is maintained as KG whereas the WM unit is maintained as EA (Also unit of issue is maintained as KG in WM view) also in additional tab the conversion for KG to EA is maintained.

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 17, 2016 at 01:38 PM

    Could you please share the conversion detail (additional data) which you have maintained in the system.

    Also could you share (if possible) what type of material is this where Base unit is KG and WM unit is EA

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Gopal ,

      Looking at above screen it is very difficult to suggest what may be wrong. Could you please take help from development team and ask them to put a breakpoint at Line 110 and let you know which criteria fails. Which lead the system to give the error message L0700

      error.jpg

      error.jpg (45.9 kB)
  • Nov 17, 2016 at 08:55 PM

    Did you previously have the unit of measure EA for a material... and that alternate unit is now removed? Check in your table LTBP... there is probably a record there where the Material and Alternate Unit (ALTME) combination is no longer a valid conversion and is not in the table MARM any longer.

    Add comment
    10|10000 characters needed characters exceeded