Skip to Content
avatar image
Former Member

Automatic settlement rule

Hi

I have done the following settings to get automatic settlement rule for project.

1. Created a project and assigned the settlement rule as WBS for cost receiver

2. In strategy , I have assigned " copy rule from superior object, WBS element" and same strategy to project profile. Settlement profile to project profile

3. Thogh created settlement rule manually for the WBS element, while for subordinate WBS element no SETC status found.

What may be the possible reason.

Zinni

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 22, 2009 at 07:30 AM

    Hi

    You run the CJ88 for the WBS and check the status the SETC will be there. Intially the status will not visible until you do the settlement for the WBS.

    No need to create manually the settlement rule, since you maintianed the settings for auto creation.

    Thanks

    S.Murali

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 22, 2009 at 06:17 AM

    Did you run the transaction CJB2?

    Add comment
    10|10000 characters needed characters exceeded